User guide

Page 117
Alternate Installation Procedures for DishPro Systems
6. The receiver will begin taking a software upgrade. You will see the
message shown below.
7. When the software upgrade is complete, you will need to go back to
the Point Dish/Signal screen. To do this, open the Main Menu by
pressing Menu and then 6-1-1 on the remote.
8. If you removed any switches in step #1, reconnect them now, and
connect the Satellite In port on the receiver's back panel to any avail-
able receiver port on your switch. (See the wiring diagrams in Chapter
4 for more details.) If you shortened the cable between the LNBF and
your receiver as requested in step 3.b, you can now reinstall cable
that's up to 200 feet in length between the LNBF and the receiver.
9. Select Check Switch. An Attention screen will open. Select Check
to run Check Switch.
10. A second Attention screen will open asking you to please wait while
your switch installation is being checked.
11. When Check Switch is complete, you will see an Installation
Summary screen. Make sure the screen shows the correct switch and
the message “Satellite reception verified” for all satellites in your sys-
tem.