User guide

Page 115
Installation Instructions
b. If your receiver is connected to a DishPro LNB or switch, but
the DishPro switch/LNB is not indicated in the Installation
Summary screen and satellite signals are missing, press OK to
return to the Point Dish/Signal screen and follow the
instructions below under Alternate Installation Procedure for
DishPro Systems below.
7. Select OK to return to the Point Dish/Signal screen. Then select
Cancel to exit the Point Dish/Signal screen.
8. An Attention screen will open. This screen asks if the mounting and
positioning of your dish is complete with a "Locked" indication in the
Point Dish/Signal screen. Since your system is already installed
and your dish is pointed for the strongest possible signal strength, you
can select Yes.
9. The receiver will begin taking a software upgrade. You will see the
message shown below.
A progress bar at the bottom of the screen will show how the software
upgrade is progressing. Once the software upgrade is complete, you
will see a second message that the receiver's memory is now being
programmed.
This message may disappear, your screen may go blank for a few
minutes, and the green light may continue to blink. This is normal and
does not indicate a problem with the receiver.
10. When the software upgrade is complete, press View and you should
now be able to watch TV programming. To activate your program-
ming on this newly installed receiver, call 1-800-333-DISH (3474).