User guide

Page 113
Appendix A
INSTALLING A RECEIVER INTO AN EXISTING SYSTEM
These instructions guide you through the installation of your new DishPro
satellite receiver in an existing system where your satellite dish(es) has
already been installed and pointed for the strongest possible signal. If your
dish antenna(s) is not already installed, you will need to follow the
Installation Instructions found in Chapter 4.
There are two families of satellite receivers that are covered by these
installation instructions.
• DishPro Receivers which have the DishPro logo shown below.
• Legacy receivers which do not have the DishPro logo.
If you are installing a DishPro receiver into one of the dish antenna
systems listed below, go to step 1 under Procedure to start your
installation:
• DishPro receiver into a dish antenna system with DishPro LNBFs and
switches.
• DishPro receiver into a dish antenna system with Legacy LNBFs and
switches.
If you are installing a Legacy receiver into a dish antenna system with
Legacy LNBs and switches, complete the installation using the
instructions which came with the Legacy receiver as well as instructions
which came with the Legacy LNBs and switches.
Important: If are trying to install a Legacy receiver (no DishPro logo)
into an existing system with DishPro LNBFs and switches, you will need
a DishPro Adapter. For more information on this, contact your DISH
Network retailer or call 1-800-333-DISH (3474) for more information.
They will give you the instructions for doing this installation with the
DishPro Adapter.