User guide

Page 66
Installation Instructions
Chapter 4
4. Assemble the satellite dish as shown below.
Note: There are steps that require you to run cable through parts
of the antenna assembly, so do not connect the LNBF(s) or the Y
Bracket and do not tighten the mast clamp on the mast until
specifically instructed.
5. Loosen both skew bolts and set the skew by rotating the dish
mounting bracket to align the red mark with the required angle on
the skew scale which you wrote down on page 65. Tighten the
skew bolts securely to keep the dish from rotating.
Top Part
of Mast
Bubble Level
Mast
Tip: Once the
skew angle is
set, do not try to
fine-tune this
angle when aim-
ing the dish.