User guide

Page 92
Installation Instructions
Chapter 4
TWO DISHES,THREE DUAL-OUTPUT LNBFS,ONE SW44 SWITCH,
T
WO SW21 SWITCHES,FOUR RECEIVERS
This diagram omits grounding for clarity. Make sure to
ground the system in accordance with the National
Electrical Code (NEC) and all local electrical codes.
See Grounding the System on page 94 for guidance on
grounding.
Note: In this installation, only two receivers will get signal from all
three LNBFs. The other two receivers will get signal from only two
LNBFs.
When you set up your system following this diagram and run Check
Switch,theInstallation Summary screen should look similar to
the one shown below for the two receivers connected to the SW21
switches.