User guide

lPage 87
Installing a Legacy Multiple Dish System
9. Tilt the dish up by two degrees, and then tighten both bolts. Now, try
turning the dish back and forth again. Repeat these steps, raising and
lowering the elevation, until you find the satellite signal.
10. When you have a signal, turn the dish assembly back and forth very
slightly until the signal strength bar displays the strongest possible
signal strength. Tighten the mast clamp bolts. Then, loosen the
elevation bolts and adjust the elevation of the dish up and down
slightly until the signal strength bar displays a strong signal. Tighten
all the bolts in the dish assembly so that the dish cannot be moved.
11. Mark the final locations on the mast and mounting bracket with a
permanent marker. This assists you later if you have to realign the
dish because of movement due to wind or weather. Do not scratch the
painted surfaces to mark them. This will cause rusting.
12. Connect the LNBFs to the switch(es) using the instructions that came
with your switches. (See the Alternate Wiring diagrams on page 88
for more information.)
13. Connect the switch(es) to the receiver using the instructions that came
with your switches.
14. Run Check Switch from the Point Dish/Signal menu. Verify that
you have signals from all the satellites in your system and that the
correct switches have been identified.