User guide

Page 84

Installation Instructions

Chapter 4

If not, open the Main Menu and press 6-1-1 on the remote. Select

the 119 West option if it is not already selected.

7. Turn the dish back and forth very slowly, until the signal strength

bar turns green. This shows that you have found the signal.

Note: If you cannot find the signal, turn the dish back to the

original azimuth setting. Then, loosen both elevation bolts just

enough to be able to tilt the dish. Tilt the dish up by two degrees,

and then tighten both bolts. Now, try turning the dish back and

forth again. Repeat these steps, raising and lowering the elevation,

until you find the satellite signal.

8. When you have a signal, turn the dish assembly back and forth

very slightly until the signal strength bar displays the strongest

possible signal strength. Tighten the mast clamp bolts. Then,

loosen the elevation bolts and adjust the elevation of the dish up

and down slightly until the signal strength bar displays a strong

signal. Do not adjust skew. Tighten all the bolts in the dish

assembly so that the dish cannot be moved.

9. When you have the strongest possible signal, press the CANCEL

button on the remote to exit the Point Dish/Signal menu. The

receiver displays an Attention message asking whether the

installation is complete. If the answer is yes, select the Yes

option. The receiver will begin taking a software upgrade. You

will see a Warning that “Vital program information will now be

downloaded into your receiver.” You will also see a status bar

showing the progress of this upgrade.