User guide

lPage 83
Installing a Legacy DISH 500 System
2. Attach the Y-bracket, using the Y-bracket screw.
3. Connect the RG-6 cable from the Satellite In connection on the back
of the receiver directly to the Twin LNBF, as shown below. Be sure
there are no multi-dish switches between the LNBF and the receiver.
4. Attach the LNBF to the Y-bracket using the two LNBF screws.
5. Slide the dish assembly down on the mast if not already installed.
Make sure the pivot bolt rests on the top of the mast. Turn the dish
assembly so that it points in the general direction of the satellite,
using the azimuth angle from page 65.
6. Turn ON the television and the receiver. The Point Dish/Signal
menu should be displayed.