User guide

Page 80
Installation Instructions
Chapter 4
2. Thread both coaxial cables through the mast (optional) support
arm and the Y-bracket. Make sure the cable(s) labeled “119” are
threaded through the 119 side and the “110” cable(s) are threaded
through the “110” side as shown.
3. Attach the Y-bracket using the Y-bracket screw. Connect the
“119” cable(s) to one LNBF and the “110” cable(s) to the other
LNBF. Attach the LNBFs to the Y-bracket using the two LNBF
screws.
4. Slide the dish assembly down on the mast if not already installed.
Make sure the pivot bolt rests on the top of the mast. Turn the dish
assembly so that it points in the general direction of the satellites,
using the azimuth angle from page 65.
5. Connect the RG-6 coaxial cable from the “119” LNBF directly to
the Satellite In connection on the receiver’s back panel. You
may temporarily need to use a barrel connector in place of where
your switch will go later to complete this step. Do not connect the
multi-dish switch at this time.
6. Turn ON the television and the receiver. The Point Dish/Signal
menu should be displayed. If not, open the Main Menu and press
6-1-1ontheremote.
7. Make sure the check mark is next to 119 West.Ifitisnot,move
the highlight to 119 West and press Select on the remote control.
8. Turn the dish back and forth very slowly, until the signal strength
bar turns green. This shows that you have found the signal.
110 West
119 West
110 West
119 West
119 West