User guide

lPage 73
Installing a Multiple Dish DishPro system
6. When Check Switch is complete, you will see an Installation
Summary screen similar to the one shown below.
The Installation Summary should contain the following
information to show your receiver is connected to the DishPro Single
LNBF:
• LNBFs - Single
• Dish Input -1
• Satellite - Conn
If your screen matches this description, go to step #8. If not, do one of
the following:
• If “Xs” appear in the Satellite line, check all connections and then
select Retest to run Check Switch again.
• If, by chance, the number for the satellite you want to point at
appears on the Satellite line, continue on to the next step.
7. Select OK to exit back to the Point Dish/Signal menu.
8. Point the dish for the strongest possible signal, following the
instructions that came with it.
9. Connect any switches in your system, using the instructions that came
with the switch(es) and the DishPro wiring diagrams starting on
page 74.
10. Select Check Switch from the Point Dish/Signal menu. When
the Check Switch menu opens, select Check. When the procedure
completes, you will see the Installation Summary screen
again.This time you should have confirmation for all satellites within
line-of-sight of your dish(es). You should also see that the switch(es)
in your system have been correctly identified. Refer to the DishPro
wiring diagrams for examples of installation summary screens.
11. Select OK to exit this menu, and then Cancel to exit the Point
Dish/Signal screen.