Specifications

Plug in all necessary cable connections to the back of the NOMAD.
(Note: Plugging the receiver and NOMAD into an independent power strip
is recommended.)
NOMAD Rear-Panel Connections
Power: Connects the 12 VDC 4 AMP power supply to the
NOMAD. (Note: Only use the power supply provided by
MotoSAT™.)
Control Cable: Connects the Mount to the NOMAD by way of
a 9-conductor Data Cable. The cable and connector are color-
coded to insure proper configuration. (See Figure at Right).
Serial Port: Used to provide software upgrades.
Out to TV Receiver: Coaxial connection from the NOMAD to
the satellite/LNB input on the satellite receiver.
In From Dish: Coaxial connection from the Mount to the
NOMAD.
NOMAD CABLE CONNECTIONS
P1
+12V
P2
GND
P3
NOT USED
Power Connector: Connects the 12 VDC 4 AMP
power supply to the NOMAD. (Note: Only use the
power supply provided by MotoSAT™).
Control Cable: Connects the NOMAD to the Mount via
a 9 conductor cable. The cable is color-coded to insure
proper configuration. (See Figure Above).
Power Control Cable Serial Port
In From
Dish
Out to TV
Receiver
5