Specifications

TO FIND A SATELLITE:
1. Turn on the power by pressing the POWER button.
2. Wait for approximately 5 seconds for the NOMAD to complete
its power up sequence.
3. Press the FIND button and the dish will search out and lock
onto the properly programmed satellite(s).
NOTE: Pressing the FIND button after you have locked onto a satellite will
control one of two functions, depending on your system type:
- Non-Skewable Mount: Pressing the FIND button while on satellite enables
you to toggle between multiple satellites. Pressing the FIND button while
locked onto a satellite will direct the system to go to the next satellite in
order such as:
 •DIRECTV
©
can toggle between 101 and 119.
 •Dish Network
©
can toggle between satellites 110 119 and 129.
 •Dish Network
©
International East can toggle between satellites
61.5, 110, and 119.
 •Dish Network
©
International West can toggle between satellites
110, 119 and 148.
 •Bell ExpressVu
©
can toggle between satellites 82 and 91.
- Skewable Mount: Pressing the FIND Button will locate all satellites
available with your LNB configuration simultaneously, and re-peak the
dish for higher signal quality. For Programming Options and their assigned
satellites, see “NOMAD Programming Options” on page 11.
TO STOW THE DISH:
1. Press the STOW button and the dish will stow, returning to the
proper travel position.
OPERATING THE NOMAD
POWER BUTTON FIND BUTTON STOW BUTTON
18