Specifications

13
WIRING TABLE
Open Face TV Mounts
The Control Cable, 9 conductors, colored coded, 22Awg stranded that connects to the mount with a
twist lock connector is configured in the following manner:
Color Code Pin Designation Mount
Destination
Counts
per Degree
Black 1
Motor, Azimuth Positive
*Brown 2
Motor, Azimuth/Skew
Negative
*Red 3
Motor, Elevation/Skew
Positive
Orange 4
Motor, Elevation
Negative
Yellow 5
Sensor, Count Azimuth
3.408
Green 6
Sensor, Ground
Azimuth/Elevation
Blue 7
Sensor Count Elevation
5.034
White 8
Power, Mount LED
**Purple 9 Sensor, Count Skew 8.500
* The Brown and Red wire perform a dual function when used on a Skewable
(MD500/MD1000/MHDTV/Star Choice) mounts. These wires control the Skew motors when
directed by the Nomad 2 Controller. Applying 12 volt power directly to these wires will skew the
dish.
**The Purple cable is for use on skewable dishes but it WILL NOT effect the operations of a non-
skewable dish when it is connected (or not connected).
The Mount is coil wrapped inside with the following cables and wire:
2 ea RG179 Teflon coated coax cables (can do four (4) if required)
1 ea Control Cable, 9 conductor cable, colored coded, 22Awg stranded. This cable is molded
with a twist lock connector on one end and manually terminated at the Nomad 2 end
with a 9 pin connector.
2 or 4 ea RG179 coax cables terminate at the LNB will provide additional cabling for multiple
receivers.
1 ea Black and White 22Awg stranded wires carry the positive (white) voltage and ground
(black) to the LED which is used to illuminate the dish face.
For any questions or comments please contact our
Technical Support Department at 1-800-247-7486 Ext 338.