User guide

Chapter 11
76
Connecting a VCR
Setting Up the Receiver to Control Your VCR
Use this section to set up the receiver to control your VCR so that you can use VCR timers. The
receiver’s front panel IR BLASTER sends a signal to control the VCR. This signal can bounce off
walls and other objects on its way from the receiver. However, shelves or smoked glass between
the receiver and VCR can block the signal. Make sure nothing blocks the signal and that you don’t
have the VCR too far away from the receiver.
Chapter 11 381.fm Page 76 Thursday, May 21, 2009 6:19 PM