User`s guide

EchoStar Technologies Corporation
143884
4
11. ViP622 DVR to TV2(s):
a. Connect the remote TV(s) to an existing wall cable outlet and power on the TV(s).
b. Find three side-by-side channels on the remote TV(s) that show no video (they show snow,
static, etc. instead). These three channels must be in the 21-69 range if your TV(s) will be set in
Air Mode or in the 73-125 range if using Cable Mode.
c. Tune the remote TV(s) to the middle channel of the side-by-side channels you found, and note
the mode the TV is in.
d. Connect the cable from the CH 21-69 Out port to the existing wall cable outlet. Attach the
yellow CH 21-69 Out sticker to this cable near the receiver.
e. Back at the nearby HDTV, go to the Modulator Setup menu by pressing MENU, selecting
System Setup (6), Installation (1), then Modulator Setup (5) using Remote Control 1. Set the
TV2 OUT mode and channel the same as you set the remote TV(s), then select Done.
f. Verify that you have a good picture on the remote TV(s). If not, you may need to change the
cable connections on the splitter that sends the TV signal throughout the house. Make sure that
the CH 21-69 Out port is connected to the input of the splitter, and that the remote TV(s) is
connected to an output of the splitter. Attach the TV2 sticker on or close to the remote TV(s),
and write on the sticker which channel the TV needs to be on to view satellite programming.
g. In the How to Watch TV on TV2 section of the included TV2 Quick Reference Guide, write
down the TV2 Out channel, and if applicable, the VCR channel and whether the VCR needs to
be on or off.
Note: To display TV1 programming on the “Ch 21-69” output, follow the steps above and
enable TV1 Out using the Modulator Setup screen, setting TV1 Out to the same mode and at
least two channels away from TV2 Out. If TV1 has locks set, you will need to enter the
password to enable TV1 Out. Set the remote TV(s) to the same mode and channel as TV1 Out.
Refer to Connecting to the Remote TVs (TV1 or TV2) in Chapter 12 of the User’s Guide for
additional information.
12. Program TV mode and Limited Mode as needed: Program each remote control to the TV. If you
want to program the TV in Limited Mode to send only power and volume commands, use the steps
listed in Controlling Other Components in Chapter 10 of the User’s Guide.
13. Recover button: Program the RECOVER button for Remote Control 2 to the same channel as each
remote TV, using the steps listed in Controlling Other Components in Chapter 10 of the User’s Guide.
Confirm that the RECOVER button works for each remote and TV.