Operating Instructions

BUILDING YOUR RACE TRIKE (continue)
KEEP THIS INSTRUCTION MANUAL AS IT CONTAINS IMPORTANT
INFORMATION FOR FUTURE REFERENCE.
Due to continuous product improvements, the pictures on this manual
may differ slightly from the actual product.
FAO
®
and FAO Schwarz
®
names and logos are trademarks or registered trademarks.
All rights reserved. www.fao.com
Distributed by and © 2020 MerchSource, LLC. Irvine, CA 92618.
For customer support please call 1-888-987-6533.
Printed in China
BUILDING YOUR RACE TRIKE
DIY RC RACE TRIKE
4. 1 x
Cross Screw
( 12.6 x 12 PWB x 8 )
5. 2 x
Cross Screws
( 2.3 x 8 PWB x 8 )
O. 1 x
Circuit Baoard
Q. 1 x
Battery Cover
with Screw
1. 2 x
Short Cross Screws
( 2.3 x 6 PB )
Insert the circuit board into the chassis.
Mount the front tires to the front wheels. Attach right axle to rear wheel .
2
4
5
1 2
3 4
5
Attach all wires to the ports marked R/W/B/Y on circuit board case.
NOTE: Circuit Board - R (connect Red wire) W (connect White wire) B (connect Blue wire) Y (connect Yellow wire)
1
3
On/O
Switch
6
7
8 9
J. 1 x
Chassis
K. 2 x
Front Tires
M. 1 x
Rear Axle
with Rear Tire
N. 1 x
Rear Axle
L. 2 x
Shocks
I. 1 x
Shell Body
P. 1 x
Top Decorative Bar
3. 2 x
Long Cross Screws
( 2.3 x 8 PB )
Attach rear axles/ rear wheel to rear
chassis.
Attach the left and right shocks to rear
axles/ rear chassis with screws.
Snap the Top Decorative Bar to the top of the Shell Body.
Snap the shell body to the chassis.
Insert screws from the interior of the
battery compartment.
On the underside of the trike, insert 4 “AA”
1.5V batteries (not included) in the
positions shown etched in the battery tray.
When installing the batteries, the batteries
should press the cloth belt under, so that
when removing the batteries, the cloth belt
will easy to remove the batteries out. Add
the battery cover and tighten the screw
using a Phillips or Cross screwdriver to
secure the cover.
2. 4 x
Cross Screws
( 2.3 x 6 PWB x 6 )