Specifications

PowerPro II

CopyPro PowerPro II

Installation - Unpacking

Figure 2: PowerPro II, unboxed, but still in protective shipping foam

Unpacking

• Open the top of the box

• Lift the PowerPro II by gripping the underside of the narrow sides of the unit

• Set the PowerPro II and foam on a sturdy, flat surface

• Support either end of the PowerPro II with an arm and carefully pull the foam off the

elevated end. Repeat for the shipping foam on the other end

Note:

• Printer is shipped with black ribbon installed

• Printer is shipped with top cover secured by plastic wrap

Re-packing for shipment

• Important: Make sure Printer Chassis is locked. Check by lifting chassis up, chassis

should not move. To re-lock, pull Chassis Lock Knob out, then release and check by

lifting chassis, when locked the chassis will not open. (See Parts Identification

section for location of Chassis Lock Knob)

• When re-packing for shipment, secure outer top cover by plastic wrap or tape before

placing printer into foam pieces