Specifications

PowerPro II

CopyPro PowerPro II

Figure 15: Printhead cleaning with ribbon removed

Printhead Cleaning Procedure

• If tray is in, press Tray Button to extend tray

• Remove the top cover by carefully lifting and pulling forward. Set the cover aside.

• Open printer chassis by: Pulling chassis release knob and lifting chassis up by chassis

handle

• Remove Ribbon Supply Roller from printer and place on CD Tray, this will expose

the printhead. (As an alternative remove ribbon completely from printer)

• Printhead is now visible from the inside of Printer chassis

• Move the Supply Ribbon roller and ribbon forward and away from the front of the

unit, exposing the printhead.

• Use a cotton swab or Q-tip with a few drops of isopropyl alcohol to gently rub the

printing surface of the print head.

• Use a sweeping motion starting from one end of the printhead to past the other end to

remove any dust particles (do not lift up Q tip in middle of printhead since that may

leave residue in that area)

• Allow the printhead a minute to dry before moving ribbon spindle back on to chassis

• Printer will wind slack ribbon at power ON, or pressing Start and Tray button

simultaneously will also wind slack ribbon

Chassis Release

Button is located

inside case