Setup guide

EliteMicro Setup Guide
This brief setup guide is provided to get the EliteMicro operational out of the box. Once you
get the system operational, complete online help can be accessed from the DiscJuggler
HELP Section.
Step 1
Unpacking the Hardware:
Your EliteMicro system is shipped in one main carton and if the printer adapter kit is
ordered, a second carton is included. If you purchased the CD Printer, it is shipped in a
separate box.
Carefully open the box and remove the top protection cardboard sheet. You will then be
able to remove the following:
Main Carton w/ EliteMicro Printer Adapter Kit Carton
 USB 2.0 Cable
 DB9 Serial Loader to PC Cable
 AC Power Cord
 Installation CD for EliteMicro
Software
 Hardware Setup Manual
 Printer Guide Plates (2 pcs)
 Printer Control Cable
 Printer Parallel Cable
 Installation CD for Label Printing
Software
Set the components on a table that will hold the EliteMicro unit and your PC. Next, by lifting
straight up, carefully remove the foam container and foam protection over the EliteMicro
unit. You will see the EliteMicro in a plastic bag.
Grasp the EliteMicro on the top section and place the other hand underneath the unit.
Gently lift out of the shipping box and set onto a table.
Remove the EliteMicro out of the bag and place all shipping components back into the
shipping carton for future use. It is important to always ship the EliteMicro in its proper
container so storage of the box and accessories is important. In the event you misplace your
packaging and need to ship the EliteMicro contact the service department and a new
shipping container will be shipped out.
Next remove the printer from its shipping carton and place all the components on the table.
Account for all the components.
9