Setup guide

EliteMicro Setup Guide

Step 12

Start The Job

Now you are ready for the unit to start a job. Click on the START button.

The EliteMicro should move to the input spindle, pick up the 1

CD (your master) and place

it into the recorder. The image on the CD will be copied to the hard drive. Then the CD

Master will be removed from the Drive and place onto the output spindle. Then the

EliteMicro will pick up a blank media and insert it into the recorder. The image will be

recorded onto the media. Next the EliteMicro will pick the recorded disk from the drive move

to the top of the column and wait for the CD Printer to open. The recorded CD will be placed

into the printer tray and the CD will be printed. After printing the EliteMicro will pick up the

CD from the printer and place into the output spindle. It will repeat this and the cycle will

continue until the 25 copies are completed.

If the unit is trying to use a CD recorder on your PC, please read the Using Drive Assigner

section located on the next page of this guide for some steps to correct the problem.

Please observe the operation and verify that everything works smoothly. If anything does

not work, back track and review your steps. If you cannot find the problem please call toll

free 1-888-800-4041 and one of our technical support staff will gladly assist.