Setup guide

EliteMicro Setup Guide

Step 8

Load Blank CD’s and Start Duplication

You are now ready to begin a job or task on the EliteMicro. Turn on your unit if you have not

already done so. Refer to the previous page if necessary. The next steps will take you

through a typical setup and usage of the EliteMicro. It is recommended to follow these steps

and produce a test job, then move on to the many other functions and features of the

EliteMicro.

Load blank Ink Jet media, data side down, onto the input spindle. The input spindle has

three silver rods located around the outside edge of the media. Please be sure the media

does not stick together and that the media lays flat in the input spindle.

Place a CD to be copied on top of the input spindle. This will be the ‘master’ for this test run.

Use an image of 30 MB or less to allow the test run to be faster.

On the Desktop, click on the DiscJuggler ICON and the DiscJuggler will run.

Click on File, choose New and the panel below will open.

Choose Copy CDs and DVDs from the same burner

(This task will take the CD on the top of the Input Stack; load a temp image to the hard drive

and copy from the temp image.)

Screen of Start of a New Job