Setup guide

EliteMicro Setup Guide

Step 6

Installation of Labeling Software

If your EliteMicro was purchased with the Inkjet Printer Adapter Kit, you will need to install

the label making software included with the kit.

Locate the Discus CD Labeling Software CDR and insert into your CDROM drive on the PC

that is connected to the EliteMicro. The menu below will be displayed, choose install to hard

disk. NOTE: Be sure that your PC can handle the 500MB and not affect the minimum

requirements of the EliteMicro hardware.

When the Discus Labeling Software begins to install, it will first load Apple QuickTime onto

your PC. Following the instructions on the installation. When the screen asks to register the

QuickTime, simply click on Proceed without entering anything.

Once the Discus installation is complete, a Discus LE icon will be placed on your desktop.

Click on the DiscusLE icon and verify that the Discus installed correctly. Close Discus and

remove the CDROM.