Setup guide

EliteMicro Setup Guide
Step 3
Installation and Connection of AC Power, USB 2.0 and Serial Link
Plug the USB 2.0 and Serial Cables into each of their identified connections located on the
rear of the EliteMicro unit. These connections are identical to the common connections of
standard computers.
Arrange your PC hardware on the same table as the EliteMicro unit. Connect the other ends
of the USB 2.0 and Serial Cables to their respective connections on your PC.
Plug the power cord into the power supply of the EliteMicro, also located on the rear side.
Plug into a standard 115VAC outlet.
It is recommended to plug these components into a common plug strip with AC filtering, as
is common with most high-end computers. Also if the unit is to be located in an area where
the utility or power company experiences frequent outages, utilizing a UPS is strongly
recommended.
Connection of AC Power, USB 2.0, Serial and Printer Control Cables
NOTE: Review your entire unit and be sure that you have four cables connected to
the EliteMicro Unit, three (3) cables connected to the printer and (3) cables
connected to your PC.
14