Elite Setup Guide- Thermal Printer Hardware Installation and Setup Guide For PowerPro Thermal Printer This Printer Guide is to be used in conjunction with the Elite Hardware and Setup Guide.
Elite Setup Guide- Thermal Printer Service and Contact Information Free lifetime technical support. Disc Makers' Technical Support Department is here to help you every step of the way with your duplication system. Our goal is to minimize your downtime and maximize the return on your investment. We offer FREE technical support to you for as long as you own your duplicator. If you run into any problems or have any questions, call us at 1-888-800-4041.
Elite Setup Guide- Thermal Printer Thermal Printer Option Installation of the PowerPro CD Printer Review the printer documentation included in the carton with the PowerPro printer. Install the thermal ribbon and ready the printer for printing. Perform and complete any printer checks before installing the printer onto the Elite unit. Note to obtain additional supplies for the printer call toll free 1-888-800-4041 or online at Discmarket.
Elite Setup Guide- Thermal Printer Step 1 If your unit was shipped with the Inkjet Tray attached, remove the InkJet Printer tray and keep the mounting hardware. If your unit was shipped without the Inkjet Printer Tray, Proceed to Step 3A Step 3A Locate the Thermal Tray and place it onto the Elite unit Using the hardware removed from the inkjet tray, install the FRONT thumb screws to secure the Thermal Tray.
Elite Setup Guide- Thermal Printer Step 6 Connect the AC Power cord, the Printer Control Cable and the Parallel cables as required. Step 4 With the Thermal Tray mounted, prepare the PowerPro Pinter for placement onto the tray **The Printer is heavy, be careful when attempting to place the printer onto the Elite unit** Step 7 Apply power to the printer and allow it to become ready for service. Open the ACC on the Elite host system and follow alignment steps.
Elite Setup Guide- Thermal Printer With the printer set up, follow these steps to allow final set-up: Open the ACC (Autoloader Control Console) this will allow the printer to be aligned. When the ACC is opened, click on Run Diagnostics and allow the loader and printer to cycle. Once complete all the areas should be green. If any of the circles are RED, STOP DO NOT CONTINUE until steps are taken to correct the issue. If all are GREEN then click on the Comm Center folder.
Elite Setup Guide- Thermal Printer Now test the printer. With the printer aligned to load the CDDVD correctly, open the PowerPro label software. Make a test image in the software and print several discs manually by loading the printer by hand. STOP : If the printer does not print your label manually, STOP and take steps to print your label. DO NOT PROCEED IF YOU CANNOT PRINT MANUALLY. Once the test image is established and approved we can move to using the autoloader and processing discs automatically.
