Setup guide

T www.discmakers.com 1-888-800-4041 7
This brief setup guide is provided to get the EliteMicro operational out of the
box. Once you get the system operational, complete online help can be
accessed from the DiscJuggler HELP Section.
Step 1
Unpacking the Hardware
Your EliteMicro system is shipped in one main carton, if the printer adapter kit
is ordered, a second carton is included. If you purchased the CD Printer, it is
shipped in a separate box.
Carefully open the box and remove the top protection cardboard sheet. You will
then be able to remove the following:
Set the components on a table that will hold the EliteMicro unit and your PC.
Next, by lifting straight upward, carefully remove the foam container and foam
protection over the EliteMicro unit. The EliteMicro will be in a plastic bag.
Place one hand on top of the EliteMicro, and the other hand underneath the
unit. Gently lift out of the shipping box and set onto a table.
Take the EliteMicro out of the bag and place all shipping components back into
the shipping carton for future use. It is important to always ship the EliteMicro
in its proper container so storage of the box and accessories is important. In
the event that you misplace your packaging and need to ship the EliteMicro
contact the service department and a new shipping container will be sent out.
Next remove the printer from its shipping carton and place all of the parts on
the table.
Account for all the components.
Main Carton w/ EliteMicro Printer Adapter Kit Carton
• Firewire® PCI Card Box • Hardware Setup Manual
• Firewire® Cable • Printer Guide Plates (2 pcs)
• DB9 Serial Loader to PC Cable • Printer Control Cable
• AC Power Cord • Printer Parallel Cable
• Installation CD for EliteMicro
Software
• Installation CD for Label Printing
Software