Setup guide

T www.discmakers.com 1-888-800-4041 23
Step 8
Load Blank CDs and Start Duplication
You are now ready to begin a CD-R or DVD-R (if your EliteMicro is a DVD-R
version) duplication job or task on the EliteMicro. The next steps will take you
through a typical setup and usage of the EliteMicro. We recommend that you
follow these steps and produce a test job, then move on to the many other
functions and features of the EliteMicro.
• Load blank inkjet printable CD-Rs or DVD-Rs onto the input spindle. The
input spindle has three silver rods located around the outside edge of the
discs. Make sure the media lays flat in the input spindle and does not stick
together.
• Place a CD-R or DVD-R to be copied on the top of the input spindle. This will
be the "master" for this test run. We recommend that you use a CD with an
image of 30MB or less to allow for a faster test run.
• On the desktop, click on the Elite/DiscJuggler icon. The DiscJuggler pro-
gram will open.
• Click on File / New and the panel pictured below will open.
• Choose Copy CDs and DVDs from the same burner. This task will take the
CD on the top of the input stack, load a temp image to the hard drive, and
copy from the temp image.
Screen of Start of a New Job