Setup guide

T www.discmakers.com 1-888-800-4041 21
Step 7
Installation of Labeling Software
If your EliteMicro was purchased with the Inkjet Printer Adapter Kit, you will
need to install the label making software included with the kit.
Insert the Discus CD Labeling Software CD-R into your CD-ROM drive on the
PC that is connected to the EliteMicro. The menu below will be displayed,
choose install to hard disk. NOTE: Be sure that your PC can handle the 500MB
and not affect the minimum specifications of the EliteMicro hardware.
When the Discus Labeling Software begins to install, it will first load Apple
QuickTime onto your PC. Follow the instructions on the installation. When the
screen asks to register the QuickTime, simply click on Proceed without entering
anything.
Once the Discus has completed installation, a DiscusLE icon will be placed on
your desktop.
Click on the DiscusLE icon and verify that the Discus software installed correct-
ly. Close Discus and remove the CD-ROM.
Finally, follow the instructions provided with the printer to install the printer driver
on your PC.