Setup guide

T www.discmakers.com 1-888-800-4041 13
Step 4
Installation and Connection of AC Power, FireWire® and Serial Link
Plug the FireWire® and Serial Cable into each of their identified connections
located on the rear of the EliteMicro unit. These connections are identical to the
common connections of standard computers.
Plug the power cord into the power supply of the EliteMicro, also located on the
rear side. Plug into a standard 115VAC outlet.
Arrange your PC hardware on the same table as the EliteMicro unit.
It is recommended to plug these components into a common outlet strip with
AC filtering, as is common with most high-end computers. Also, if the unit is to
be located in an area where the utility or power company experiences frequent
outages, utilizing a UPS is strongly recommended.
NOTE: Review your entire unit and be sure that you have four cables connect-
ed on the EliteMicro unit, three (3) cables connected on the printer and (3)
cables connected to your PC.
Connection of AC Power, FireWire®, Serial and
Printer Control. (Printer removed for clarity.)