Setup guide

T www.discmakers.com 1-888-800-4041 11
Step 3
Installation of the Printer Adapter Kit
Locate the two sheet metal printer guides that are included with the EliteMicro
Printer Adapter Kit. Arranve the guides as shown in Figure 9.1 on the next
page.
Remove the black knob that will hold the two guides together. Place the guides
together as shown in 9.2 and then replace the black knob, tighten securely.
(hand tighten).
Next arrange the guide as shown in Figure 9.3 and USING THE INSERTION
ANGLE INDICATED, place the EliteMicro Recording unit into the guide.
Next insert the CD Printer as shown in Figure 9.4 and USING THE INSERTION
ANGLE INDICATED place the CD Printer into the guide. Holding the printer
with hands on the left and right side, insert the front of the printer in at an angle
first, then let the back section “drop into” place. The printer should be securely
inserted into the print holder tray and should be completely level.
Review your configuration and confirm it matches Figures 9.5 and 9.6.
Plug in the CD Printer Control Cable (mini din cable similar to a keyboard cable
and has connectors on both ends) into matching connectors in the rear of the
EliteMicro and the rear of the Printer. (Figures 9.7 & 9.8)
Plug in the parallel printer cable provided with the EliteMicro into the rear of the
printer and into the parallel port of your PC. (Figure 9.8)
Place the AC Power Adapter that was provided with the CD Printer next to the
rear of the printer and plug into a standard 115VAC outlet.
If you received a new printer with the EliteMicro, follow the printer documenta-
tion. Power on the printer and install the print cartridge that was shipped with
the CD Printer.
The EliteMicro is generally preset for the CD Printer. Once the unit is connect-
ed and operating you may have to perform an alignment of the printer.
Please note that in addition to installing Label Making Software you will be
required to install the Printer Driver included with your printer. Please refer to
the printer manual for details.