User guide

User Guide v.1.0 www.discmakers.com/techsupport 27
15
IF ERROR CODE 15 IS SHOWN, IT REPRESENTS THAT THE
VACUUM PICKING ARM DID NOT REACH THE DRIVE POSITION
WITHIN 4 SECONDS FROM THE Z POSITION STARTING POINT.
THIS TAKES PLACE WHEN THE VACUUM PICKING ARM HAS
DECENDED TO THE APPROPRIATE DRIVE LOCATION AND
SHOULD MOVE HORIZONTIALLY TO CENTER THE DISC OVER
THE OPENED DRIVE TRAY BUT FAILS TO DO SO IN THE
SPECIFIED ALLOTED TIME. (THIS ERROR IS ONLY SHOWN
WHEN THE Z-MANEUVER IS ENABLED).
UNABLE TO
PERFORM THE
HORIZONTAL Z
MANEUVER FROM
THE STARTING
POINT TO THE
ORIGINAL
POSITION
16
IF ERROR CODE 16 IS SHOWN, IT REPRESENTS THAT THE
VACUUM PICKING ARM DID NOT DECEND AND PLACE THE DISC
INTO THE OPENED DRIVE TRAY WITHIN 4 SECONDS AFTER THE
VACUUM PICKING ARM HAS CENTERED THE DISC ABOVE THE
OPENED DRIVE TRAY. (THIS ERROR IS ONLY SHOWN WHEN
THE Z-MANEUVER IS ENABLED).
UNABLE TO
PERFORM
VERTICAL Z
MANEUVER WHILE
PLACING DISC IN
DRIVE TRAY
17
IF ERROR CODE 17 IS SHOWN, IT REPRESENTS THAT THE
VACUUM PICKING ARM DID NOT RETURN TO STARTING
HORIZONTAL POSITION FOR THE REVERSE Z-MANUEVER
WITHIN 4 SECONDS TO RETURN THE DISC TO THE OUTPUT BIN.
(THIS ERROR IS ONLY SHOWN WHEN THE Z-MANEUVER IS
ENABLED).
UNABLE TO
PERFORM THE
HORIZONTAL Z
MANEUVER FROM
THE ORIGINAL
POSITION TO THE
STARTING POINT
20
IF ERROR CODE 20 IS SHOWN, IT REPRESENTS THAT ALL OF
THE INPUT BINS ARE EMPTY. THIS ERROR COMMONLY COMES
UP EVERYTIME THE AUTOLOADER DOES NOT DETECT
ANYMORE BLANK MEDIA TO LOAD INTO THE DRIVES. IF THIS
ERROR ARRISES AND YOU ARE FINISHED, PRESS THE LEFT
ARROW TO END THE COPY PROCESS. IF YOU ARE NOT
FINSIHED, RESTACK THE BLANK MEDIA FROM THE FIRST INPUT
BIN TO THE REMAINING BINS AS NEEDED AND PUSH THE
RIGHT ARROW KEY TO CONTINUE THE DUPLICATING
PROCEDURE.
INPUT BIN EMPTY
21
IF ERROR CODE 21 IS SHOWN, IT REPRESENTS THAT THE
INPUT BIN IS MISSING. THIS ERROR INDICATES THAT AN
OBSTRUCTION, MISSING COMPONENT OR MECHANICAL
FAILURE HAS PREVENTED THE VACUUM PICKING ARM FROM
DETECTING THE INPUT BIN TO PERFORM THE ASSIGNED TASK.
INPUT BIN
MISSING
30
IF ERROR CODE 30 IS SHOWN, IT REPRESENTS THAT THE
VACUUM PICKING ARM DID NOT DETECT AN OPENED TRAY
BEFORE REACHING ITS LOWEST DESCENDING LIMIT WHEN
ATTEMPTING TO PICK UP A FINISHED DISC FROM A SPECIFIED
DRIVE TRAY.
UNABLE TO
LOCATE DRIVE
TRAY FOR
OUTPUT OF THE
DISC
40
IF ERROR CODE 40 IS SHOWN, IT REPRESENTS THAT A NEW
COMMAND WAS RECEIVED WHILE AN ERROR FLAG IS STILL
REGISTERED. IN ORDER TO PROCEED, THE PREVIOUS ERROR
NEEDS TO BE CLEARED BY USEING "C" TO REMOVE THE
PREVIOUS ERROR FLAG.
CLEAR PREVIOUS
ERROR
41
Trouble reading master disc.
Check master disc
for scratches or
defects.
60
IF ERROR CODE 60 IS SHOWN, IT REPRESENTS THAT THE
VACUUM PICKING ARM DID NOT DETECT AN OPENED TRAY
BEFORE REACHING ITS LOWEST DESCENDING LIMIT WHEN
ATTEMPTING TO PLACE A BLANK DISC INTO A SPECIFIED
DRIVE TRAY.
UNABLE TO
LOCATE DRIVE
TRAY FOR INPUT
OF THE DISC