User guide

User Guide v.1.0 www.discmakers.com/techsupport 16
7. Master Mode
The Master Mode menu is used to select between Single Master mode or Multi Master mode. For more
information on the modes, see Single Master and Multi Master Modes on page 10.
Use the Up or Down button to find the 8. Master Mode menu.
Press the Enter button to enter the Master Mode Menu and you will see
a screen similar to one of the following:
Use the Up or Down button to choose between Multi Master mode and
Single Master mode. Press the Enter button to enter your selection. The
system will return you back to the main menu.
8. Erase
Use the Erase RW menu to erase your Rewritable discs.
Use the Up or Down button to find the 8. Erase RW menu.
Press the Enter button on 8. Erase RW to enter the menu and you will
see the following screen:
There are two options:
Full Erase: This option erases the entire disc, destroying all previously
written data in the process.
Quick Erase: This option erases the index (TOC) of the
Rewritable disc, not the data section. It is much faster than Full
Erase. However, the data section may still recoverable.
Use the Up or Down buttons to select between the two options and press the Enter button to continue.
Follow the instructions shown in Setting Counters on page 10 to
continue.
Once the counters have been set, press the Enter button to confirm.
The Robotic Arm will go out and pick the discs to be erased from the Input Bin and place them into the drive. The
system will check the disc in the drive and prepare it to be erased. As soon as the checking process completes,
the Erase RW process starts.
The 0 indicates that zero discs have been erased so far. The 25
indicates the number programmed into the counter. Once all the discs
have been erased, you will see one of these PASS/FAIL screens: