User guide

User Guide v.1.0 www.discmakers.com/techsupport 12
Output Spindle.
At this point you can either put more discs on to the input spindle and
press the Enter button to continue, or press the ESC button to terminate
your
project.
Once the autoloader is through, you will see the following screen:
OK: Indicates the number of successful copies.
NG: Indicates the number of “Not good” copies.
NB: Indicates the number of “Not Burned” discs in the drive.
1.2 Making Copies in Multi Master Mode
This mode does not require you to manually load your master. Simply place the master disc(s) on top of the stack
of blank discs needed for that particular job of the master disc. This mode is ideal if you have numerous master
discs and fewer copies for each master disc.
The Multi Master mode uses the Reserve partition to temporarily store the content of the current master disc.
Once the task is complete and a new master disc has been detected, the reserve partition's content (of the
previous master disc) will be replaced with the content of the new master disc.
For more information on Multi Master Mode, see Single Master and Multi Master Modes on page 7..
Turn on your autoloader and wait until it has booted up. It should take several minutes for the autoloader to
go through its self adaptive test and auto-calibration procedures. You should see the following signifying
your autoloader is ready:
Turn on your autoloader and wait until it has booted up. It should take several minutes for the autoloader to go
through its self adaptive test and auto-calibration procedures. You should see the following signifying your
autoloader is ready:
Make sure the Master Mode is set to Multi Master mode (MM). If it is not,
use the Up or Down button to navigate to the 8. Master Mode screen. If it is
already in Multi Master mode (MM), please skip to the step that starts the
copy process.
Press the Enter button to enter the Master Mode Menu and you will see a
screen similar to one of the following:
Use the Up or Down button to select Single Master Mode. Press the Enter
button to submit your selection.