User guide

User Guide v.1.0 www.discmakers.com/techsupport 10
Chapter 2: Operation
This chapter shows each of the menu options and how they are used.
1. Copy
The Copy menu option or the front panel Copy quick key have two different modes of operation:
a.
Single Master Mode: This mode requires that a single master disc is loaded onto the hard drive prior to
initiating the duplication process. This mode is ideal if your job involves one or very few master disc(s).
b.
Multi Master Mode (Batch Mode): This mode does not require you to manually load your master. Simply
place the master disc(s) on top of the stack of blank discs needed for that particular job of the master disc. This
mode is ideal if you have numerous master discs and fewer copies for each master disc.
These modes are described in detail in “Single Master and Multi Master Modes” on page 7. If you are making
copies in Single Master Mode, continue on to the next section. If you are making copies in Multi Master Mode,
jump ahead to “Making Copies in Multi Master Mode” on page 12.
1.1 Making Copies in Single Master Mode
This process will copy your master disc on to several blank discs simultaneously. This mode requires that your
master disc is loaded into a partition on the Hard Drive. See “Load Partition” on page 18 for instructions on how
to do this.
Turn on your autoloader and wait until it has booted up. It should take a minute for the autoloader to go through its
self adaptive test and auto-calibration procedures. You should see the following signifying your autoloader is
ready:
Make sure the Master Mode is set to Single Master mode (SM). If it is not,
use the Up or Down button to navigate to the 8. Master Mode screen. If it is
already in Single Master mode (SM), please skip to the step that starts the
copy process.
Press the Enter button to enter the Master Mode Menu and you will see a
screen similar to one of the following:
Use the Up or Down button to select Single Master Mode. Press the Enter
button to submit your selection.
Go back to the 1. Copy Menu. Use the Up or Down button to navigate to the following screen:
Start the Copy Process. Insert your blank discs on to the Input Spindle(s)
and press the Enter button to enter the 1. Copy menu. You will see the