Technical data

Location of the central
vacuum cleaner
5
Central vacuum systems
The central vacuum cleaner has to be located into
the cellar, the storeroom, the garage or the hobby-
room, and in any case you have to guarantee a
sufficient air-circulation for its cooling. Consider the
acoustic and thermal emissions of the turbine motor.
•
The central vacuum cleaner should preferably
be located at the lowest point of the tubing, in
order to guarantee that even the heaviest vacu-
umed material is transported through the tubes
to the central vacuum cleaner.
If it is not possible to install the central unit on the
lowest point of the tubing, please contact the
technical office Disan.
Optimal suction depends on the tubing which should
be as short and linear as possible. As a
consequence, variations in the route should be
avoided as much as possible.
•
If possible, the vertical descent should be at a
central point of the house.
•
The tubing can be fitted under-track, inside the
walls or on the false ceiling
•
When many simultaneous operators join together,
install the reducer as in the drawing on page 6
Planning of the
tubing
Ø 50 mm
1 operator
Ø 63 mm
2 operators working
simultaneously
Ø100 mm
From 4 to 6 operators
working simultaneously
disan aspirazione -
Ø
100 mm - SP 3 mm - CEI EN 50086 - 1/2
disan aspirazione -
Ø
80 mm - SP 3 mm - CEI EN 50086 - 1/2
disan aspirazione -
Ø
63 mm - SP 3 mm - CEI EN 50086 - 1/2
disan aspirazione -
Ø
55 mm - SP 2,2 mm - CEI EN 50086 - 1/2
Location of the inlet valves:
height
Install the inlet valves at the same height of electricity
sockets or switches.
Square inlet valves or rectangular are available and
are compatible with the most popular brands on the
market.
Central unit
Z 843
Z 844
Ø80 mm
3 operators working
simultaneously
Inlet valve
Electricity
socket
Inlet valve
Switch
Z 162