Technical data

30
Central vacuum systems
2. connect the zinc-coated junction 4 on the filter
chamber of the dust separator to the inlet valves
5 with the rubber hose 6 and fix it with two collars
7 on both sides.
3. with the help of the rubber hose 8, connect the
rubber connection 9 of the motor to the breather
piping 10 by fixing it with two collars on both sides.
4. connect the electric cables 12 of the motor and
the electric power 12 V to the inlet valves 13 to
the main electric board 14. Connect also the
electrical boards of the automatic filter shaking
and the electric division box 12 V remote control
wire (optional). The schemes of the electric
distribution of the boxes can be find into its electric
box. For the models DS BC 100i and CD 125i its
electric panels are integrated in the machine.
5. connect the mains cable 15 to a control panel 16
with 380-400 Volt tension.
•
Mod. DS Super Compact
In the dust container of the central unit the following
parts are contained:
- 1 rubber hose for the connection to the breather
pipe.
- 4 collars
- 1 tube Air for the connection of the vacuum
piping.
We advise to locate the vacuum motors on the left
side of the dust separator. If differently, please
contact the technical office Disan.
Fix on the wall, near the central unit, the electric
box and, if present, the switchboard of the automatic
filter cleaner and the electric division box for 12V
remote control wire.
Steps for the connection of the central unit:
1.connect the tube Air 1 to the vacuum hose 2 of
the motor and to the zinc-coated junction 3 of the
cover of the dust separator.
2
3
1
4
10
5
13
6
7
14
11
8
16
15
9
12
Ex: Mod. DS D02
Z 862
Electronic control sequential starting device
The models equipped with an electronic control
sequential starting device are predisposed in the
production stage. If there would be any
troubleshooting please contact the technical office
Disan.
Z 870