Owner`s manual

Central Vacuum Systems

Steps for filter dismantling:

1. Turn the filter (26) upside down to expose the

fixing clamps (27).

2. Cut the clamps (27) and detach the housing (28)

from the filter (26).

3. Unscrew the clamp (29) from the filter ring (30),

remove it from the filter and set aside.

!WARNING!

The filter must be carefully replaced.

It must be replaced by another filter with the same

characteristics, otherwise you risk jeopardising the

correct operation of the vacuum cleaner.

Star filter with a 460 mm diameter for separator

160 l Cod. ER17080

Star filter with a 560 mm diameter for separator

210 l Cod. ER17081

Star filter with a 780 mm diameter for separator

580 l Cod. ER17082

Steps for filter and lid mounting onto the

central vacuum cleaner:

Mount the filter and the lid onto the central vacuum

cleaner following in reverse sequence the

procedure indicated for the disassembly of the

filter and of the lid.

The sequence of the functioning of the engine is

automatically adjusted by a meter in the electrical

panel. This allows a functioning in work-hours

equivalent for every engine.

Control the tight of the lid (14) with the filter

chamber (8). If the seal under the lid (14) has given

way unscrew the blocking screws (31) of the

locking clasps (15), and make them slide to the

bottom until the perfect closing of the lid (14). After

this operation tighten the blocking screws (31).

Sequence of the functioning

of the motors

Control of the tight

of the lid

Z 831

Z 832