Owner`s manual

Central Vacuum Systems

Functional check

of the turbine

EXTRAORDINARY MAINTENANCE

(by the installer)

Perform the following controls every year:

Filter control

and replacement

Stages to disassemble the lid:

While the system is switched off, detach the hose

(4) from the lid fitting (23). Lower the blocking

device (13). Unblock the locking hooks (15) and lift

the lid (14) together with the filter.

If there is an automatic filter shaking device,

disconnect the plug (24) from the socket (25) on

the back of the control panel.

Check whether the turbine works properly:

1. Switch the system on and set the switches of

the turbines (22) on the control panel in the

position “manual”.

2. If noisiness or the emission of vibrations is

higher than normal or in any case excessive,

contact the installer.

3.After the control remember to replace the

switches (22) of the turbine control in the

position “automatic”.

- Checking the filter conditions: check whether

the internal surface of the filter is completely white.

If it isn’t, the filter is probably pierced. Check

whether there are holes. To check, follow the steps

necessary to disassemble the lid and the filter.

- Filter cleaning: if the internal surface of the filter

is white while the external one is excessively dirty,

clean it with a brush, a compressor or a traditional

vacuum cleaner. The filter can also be cleaned by

washing it in a washing machine at low tempera-

tures. To clean the filter, follow the steps necessary

to disassemble the lid and the filter.

- Filter replacement: if the filter is pierced and

therefore no longer usable, put it in a plastic bag,

close it and dispose of it in compliance with the

rules for separate waste collection. Replace the

filter as described below.

Z 828

Z 829

Z 830