Owner`s manual

Central Vacuum Systems

2. Grasp the handle (16) and extract the container

(17). Empty the container or replace the plastic

bag (20).

Plastic bag for separator 100 l

code IE601

Plastic bag for separator 125-175 l

code IE602

Functional check of the

automatic filter shaking device

Check whether the filter shaking device works

properly:

1. Keep pressed for a few seconds button (21) on

the control panel of the shaker.

2. If noisiness or the emission of vibrations is

higher than normal or in any case excessive,

contact the installer.

Sequence procedure

In the containers without dust bag the visual

indicator (9) shows how full the dust container (17)

is and when it is covered by dust it must be

emptied.

1. Release slowly the lever (10) until when the

wheels of the container (17) are perfectly leant

on the floor.

Please notice: The insertion of the plastic bag in

the dust container is possible only through the

installation of the grill and pipe (see attached

instruction of the article)

Griglia e depressore per separatori l 100 Cod. IS05

Griglia e depressore per separatori l 125 Cod. IS07

Z 825

Z 826

Z 827

Z 824

3. Reinsert the container by setting it under the

vacuum cleaner. Please pay attention that the

visual indicator (9) remains outside. Push the

lever to the bottom so that the container (17)

goes up so that it fits tightly again in the filter

chamber (8). During the operation of hooking of

the dust container, please pay attention not to

crush the suction pipe.