Datasheet

QG series

QG65N-KDXYh-090-CAN-CFM

Transfer characteristic

CANoutput = 100*α

clipping outside measuring range

within specification up to ±45°

significant inaccuracy from ±70°

QG65N-KDXYh-090-CAN-CFM

Measurement orientation

Default 0°: horizontal, no

acceleration applied.

Cross tilt sensitivity error:

< (0,12 * cross tilt angle)² % typ.

Note:

one axis <10° tilt for max. accuracy

Note:

only one axis may exceed 45° tilt

QG65N-KDXYh-090-CAN-CFM

Connectivity (length ±10%)

Connection

M12 connectors: 1x male + 1x female (internal T-junction) (5 pins, A-coding) ( CiA303 V1.8.0 )

No bus termination inside. A CANbus always has to be terminated properly.

Wire / pin coding

Pin 1:

Pin 2:

Pin 3:

Pin 4:

Pin 5:

Shield

Vcc

Gnd & CAN_GND

CAN_H

CAN_L

QG65N-KDXYh-090-CAN-CFM

Mechanical dimensions (indicative only)

QG65N-KDXYh-090-CAN-CFM

Center function, CAN-manual, EDS-file

Centering can be done to eliminate mechanical offsets. (can be done by CAN object 300Fh)

The current sensor position will be stored as the new Center position in the internal Eeprom.

A CAN-manual is available at www.dis-sensors.com, see 'downloads'

EDS-file ( CiA306 V1.3.0) is available at www.dis-sensors.com, see 'downloads

As this device is accelerometer-based the sensor is inherent sensitive for accelerations/vibrations.

Application specific testing must be carried out to check whether this sensor will fulfill your requirements.