Datasheet

QG series
© Dewit Industrial Sensors - Oostergracht 40 - 3763 LZ SOEST - The Netherlands www.dis-sensors.com Subject to change without notice Page 2 2014-06-10
QG65-KD-090H-AI-CM
Transfer characteristic
Iout = 12 + 8*(α/90) [mA]
clipping outside measuring range
QG65-KD-090H-AI-CM
Measurement orientation
Default 0°: horizontal, no
acceleration applied.
Cross tilt sensitivity error:
< (0,12 * cross tilt angle)² % typ.
Note: one axis <10° tilt for max.
accuracy
Note: only one axis may exceed 45°
tilt
QG65-KD-090H-AI-CM
Connection
M12 male 8p connector
Wire / pin coding
Pin 1:
Pin 2:
Pin 3:
Pin 4:
Pin 5:
Pin 6:
Pin 7:
Pin 8:
Output Y
Supply voltage
Programming interface RS232 Rx
Programming interface RS232 Tx
Gnd
Centering input
Output X
Shield
QG65-KD-090H-AI-CM
Mechanical dimensions
QG65-KD-090H-AI-CM
Center function
Centering can be done to eliminate mechanical offsets.
To execute centering connect center input to ground (>0,5sec) within 1 min. after power up.
After centering you have 1 min. left for another centering.
Normally the center input should be left unconnected.