Owner's Manual

. .
1. Cleaner won't run
. I
WARNING: TO REDUCE RISK OF PERSONAL INJURY - UNPLUG CLEANER BEFORE SERVICING
Cleaner won't pick-up
or low suction
Problem I Possible Reasons
Water escaping from
Possible Solutions
1. Power cord not firmly plugged into outlet.
2. ALCI needs to be reset.
3. Blown fuse or tripped breaker.
4. Needs service.
- -
1. Dirty water tank is not installed correctly.
2. Dirt water tank is full.
1. Dirty water tank is full.
2. Dirty water tank is not installed correctly.
3. Solution reservoir not installed properly.
-
1. Plug unit in firmly.
2. Press reset button on ALCI.
3. Check fuse or breaker. Replace fuselreset breaker.
4. Take to service center or call 1-800-321 -1 134.
1.
Review Dirty Water Tank Removal and
Replacement-Pg.
7.
, 2. Emply Dirty Water Tank-Pg. 7.
1. ~rnit~ ~iity Water Tank-Pg. 7.
2. Review Dirty WaterTink Removal and Replacement-Pg. 7.
3. Review Solution Reservoir Installation-Pg. 6.
Cleaner won't dispense
I
1. Spray nozzle clogged.
solution
2. Solution reservoir not installed properly.
-
1. Clean thoroughly.
2. Review Solution Reservoir Installation-Pg. 6.
ANY OTHER SERVICING SHOULD BE DONE BY AN AUTHORIZED SERVICE REPRESENTATIVE
CUSTOMER SERVICE
(1 -800-321 -1 13%
In the event that further assistance is required, see your Yellow Pages for an authorized Royal' Dealer.
osts of any transportation to
and
from any place of repair are to be paid by the owner. The service parts used in this unit are easily replaced and readil available
from
an authorized Royale Dealer or retailer. Always identify your cleaner by the model number and manufacturing
code
wgen request-
ing information or ordering
replacement parts. (The model number appears on the back of the cleaner.)