Owner's Manual
EMPTYING AND CLEANING DIRTY WATER TANK:
;
WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS
-
UNPLUG BEFORE SERVICING.
EMPTYING DIRTY WATER TANK:
WARNING: ALWAYS REMOVE DIRTY WATER TANK BEFORE EMPTYING.
NOTE:
Do
NOT
remove dirty water tank with unit in upright position.
1.
Grasp sides of dirty water tank and push latch to release (Diagram
1).
2.
Grasp and rock tank forward out of base (Diagram
2).
3.
Unscrew dirty water tank drain cap (Diagram
3).
4.
Empty dirty water into sink (Diagram
4).
5.
Replace dirty water tank drain cap.
CLEANING DIRTY WATER TANK:
1.
Rinse dirty water tank with hot tap water.
2.
Let dry thoroughly before storing to prevent mildew from forming.
NOTE:
Do not use any chemicals when cleaning.
HOW TO CLEAN FILTER:
1. Check filter located on top of dirty water tank periodically and clean by rinsing with water when dirty (Diagram
5).
NOTE:
Make sure to replace filter after cleaning.
PLACING DlRTY WATER TANK IN BASE OF CLEANER:
.I.
Grasp handle and hook front of dirty water tank into base of cleaner, making sure front of dirty water tank is hooked securely into
the base (Diagram
6).
The dirty water tank has
2
tabs on the underside which MUST latch into the underside of the base of the
cleaner.
2.
While making sure the front of the dirty water tank is hooked on the base, rock the rear of the tank into the base of the cleaner.
Push down until it latches (Diagram
7).
The dirty water tank will need to be emptied once or twice per fill up of the clean solution
reservoir.
NOTE:
Failure to install the dirty water tank correctly, will result in poor dirty water pickup.
NOTE:
Do not store cleaner with solution in reservoir or dirty water
in
dirty water tank. Mineral deposits and mildew can
form
which will
affect the performance of your Spot
Scrubbet".
HOW TO STORE CLEANER:
1.
Flip up cord wrap located on top of cleaner just below solution trigger. Wrap cord around cleaner using the cord wrap (Diagram
8).
WARNING: DO NOT STORE SPOT SCRUBBERTM IN GARAGE OR AREA WHERE UNIT COULD FREEZE.