Owner's Manual

HOW TO' OPERATE
REMOVE AND REPLACE CLEAN SOLUTION RESERVOIR:
1. Grasp clean solution reservoir under handle and press handle release latch down (Diagram 1).
,2. Slide clean solution reservoir away from cleaner and remove (Diagram 2).
3. Unscrew cap from back of clean solution reservoir (Diagram 3). Fill reservoir with approximately 112 oz. of solution. Fill remaining
clean solution reservoir with hot tap water (Diagram 4). Replace cap.
NOTE: Use only Dirt Devile Carpet & Rug Shampoo. Using other cleaning solutions may cause excessive foaming. EkExceve foam
will muse the float to shut
off the vacuum prematurely. Using other cleaners will void your warranty
4. Line up tabs on clean solution reservoir with dots on cleaner and slide reservoir toward cleaner (Diagram 5). Make sure the clean
solution reservoir is not misaligned (Diagram 5a).
NOTE: Failure to install the clean solut,on reservoir correctly will result in poor dirty water pickup.
CARPETIUPHOLSTERY CLEANING:
NOTE: Never leave unit unattended with power on. Turn OFF when emptying and filling reservoir. Do NOT oversaturate the carpet.
IMPORTANT: For best cleaning results use steady, moderate forward and backward motion.
1. Plug cord into electrical outlet.
2. Turn power switch "onn. Switch is located on rear left side of cleaner (Diagram 6).
3. The cleaning mode selector will switch power to either the "vacuum" (Diagram 7) or the "scrub" (Diagram 7a). For very wet areas, first
try to vacuum the majority of the stain, removing as much liquid as possible. Then turn the cleaning mode selector to
"scrub" (before
.
spraying) and spray solution onto the stain. Allow the cleaning solution to penetrate stain for 2 minutes. Use rotating brush to agitate in
a forward and backward motion using smooth steady strokes (Diagram
8). Next, change the cleaning mode selector to "vacuum" to pick
up remaining moisture.
Empty the dirty water tank when:
Dirty water reaches the "FULLn line on dirty water tank OR
Float shuts off airflow, indicated by a change in pitch of the motor and reduced suction.
NOTE: Float may activate when unit is used verti~lly or turned on its side.