Technical data

2 Unpacking and assembling

2.1 Unpacking 1. Unpack the appliance and all its accessories.

2. Check the contents for completeness and possible

damages. Information regarding scope of delivery

ZPage 20, "Overview of your EQU".

2.2 Assembly

1. Insert the end of the suction hose in the intake opening

(Fig. 2) of the cylinder vacuum cleaner, until it locks with

an audible click.

2. Insert the handle (Fig. 3/1) into the upper end of the

telescopic tube (Fig. 3/2).

3. Attach the floor nozzle (Fig. 3/3) to the bottom end of

the telescopic tube (Fig. 3/4).

4. Adjust the length of the telescopic tube. Press down the

release latch on the tube (Fig. 4/1) to do this. Then

extend the telescopic tube to the desired length. Let go

of the release catch while pulling until it locks in place.

You will hear a distinct click.

Your cylinder vacuum cleaner is now ready for use.

ATTENTION:

Always transport or ship the appliance in its original

packaging to avoid damage. Keep the packaging for

such an event.

Dispose of no longer needed packaging material

according to the applicable regulations of your country.

NOTE:

Immediately contact your dealer if you have found

damage resulting from transportation.

WARNING:

Danger of injury! Only assemble the appliance if it is not

connected to the power supply. Otherwise the machine

might start up and parts of your body, hair or pieces of

clothing might be sucked in.

NOTE:

It might be necessary to push a bit harder.

02_M7100_gb.book Seite 25 Dienstag, 8. April 2008 11:00 11