Operation Manual

5 Steam cleaning

5.5 Refreshing carpets

1. Put the carpet glider base (Fig. 20/1) under the steam

base with the attached micro-fibre cleaning cloth. Oth-

erwise you will not be able to move back and forth effec-

tively on this surface.

2. Proceed as described in ZChapter 5.3, “Steam clean-

ing without the addition of cleaning agent” or ZChapter

5.4, “Steam cleaning with the addition of cleaning

agent”.

5.6 Putting the device into

the neutral position

1. Put the appliance into the neutral position by straighten-

ing the handle until it is at about 90° to the steam base

(Fig. 21), you can feel it lock into place, and the appli-

ance remains standing without support.

2. Wind up the power cord, ZChapter 6.1, “Winding up the

power cord”.

ATTENTION:

Always comply with the cleaning instructions of the man-

ufacturer of the carpet. Before starting cleaning, check

whether the particular floor surface is suitable for steam

cleaning.

NOTE:

Your steam mop is not suitable for deep cleaning carpets

or for removing stubborn stains. Even adding cleaning

agent cannot change this. To remove stubborn stains,

we recommend, before using the steam cleaner, working

on the stain beforehand with a commercial chemical

cleaner, provided the particular flooring permits this.

WARNING:

Danger of injury! To avoid risk, keep to the following

sequence at the end of the cleaning process:

1. Pull out plug.

2. Use up steam reserves completely.

3. Put device into the neutral position.

4. Allow appliance to cool for five minutes.

5. Wind up the power cord.

6. Remove micro-fibre cleaning cloth.

7. Dry micro-fibre cleaning cloth or wash if required.

90°

02_M318_gb.book Seite 49 Montag, 8. Dezember 2014 9:01 21