Operation Manual

5 Steam cleaning

8. To steam-clean, move the appliance back and forth

slowly.

9. Pull out the plug just before finishing the cleaning pro-

cess and use up the remaining steam reserves.

5.4 Steam cleaning with

the addition of

cleaning agent

1. Turn the cleaning agent regulator (Fig. 19/1) in the MAX

direction according to how much cleaning agent you

want to add.

2. Proceed as described in ZChapter 5.3, “Steam clean-

ing without the addition of cleaning agent”.

3. Cover each stretch of floor several times (at least 3) so

that a closed film of cleaning agent is produced.

NOTE:

If the steam ready indicator goes out, you can continue

working. Only if the steam produced is no longer suffi-

cient, should you release the steam button (Fig. 18/1)

and wait until the steam ready indicator (Fig. 18/2) lights

up again. Then, as required, you can wet the micro-fibre

cleaning cloth again by depressing the steam button

whilst you want to emit steam.

WARNING:

Danger of falling! Always be especially careful when

cleaning smooth floors as well as steps and stairs! Only

work with moderate amounts of steam when cleaning

smooth floors, otherwise a moisture film will be left on the

floor. Using less steam also ensures quicker drying and

reduces the risk of slipping.

ATTENTION:

Do not leave the appliance standing still when in opera-

tion. Keep it moving continuously. Otherwise there will be

increased danger of damaging the surface to be cleaned.

NOTE:

Cleaning agent will be added to the jet of steam until the

cleaning agent tank is empty or you turn the regulator

back to the OFF position.

MAX

OFF

02_M318_gb.book Seite 48 Montag, 8. Dezember 2014 9:01 21