Operation Manual

46
4Use
4.2 Steam cleaning using disinfectant
1. Check that the disinfectant tank is full. If
not, fill it (ZChapter 3.6, "Filling the
disinfectant tank").
2. Turn the disinfectant regulator on the han-
dle according to whether you want to add
a lot of disinfectant to the jet of steam or
just a little:
- for a lot of disinfectant in the jet of
steam: ‘MAX’ position (Fig. 20).
- for a small quantity of disinfectant in the
jet of steam: ‘MIN’ position (Fig. 21).
3. Insert the plug into a mains socket with a
ground/safety contact and proceed as de-
scribed in ZChapter 4.1, "Steam
cleaning" .
WARNING:
Danger of scalding when interrupting work!
 Pull the plug from the socket if you inter-
rupt work, e.g. to change attachments.
 Wait at least ten minutes before remov-
ing the fitted attachments.
NOTE:
You can also regulate steam power and
cleaning effect by adjusting the distance to
the surface to be cleaned.
max
20
min
21
off
22
NOTE:
Make sure that the controller clicks into the
position chosen. Positions between the
three marked positions are pointless and
obstruct problem-free function.
NOTE:
Disinfectant will be added to the jet of
steam until the disinfectant tank is empty or
you turn the regulator for the addition of dis-
infectant back to the ‘OFF’ position
(Fig. 22).
M317.book Seite 46 Dienstag, 20. Januar 2015 9:36 09