Operation Manual

Maintaining the appliance
Removing the rechargeable battery
ᆺPress and hold the locking mechanism for the
rechargeable battery to release it. ᆻRemove the
rechargeable battery from the appliance (Fig. 12 ).
Emptying the dust bin
ᆺOpen the release catch on the connection port
to disconnect the base appliance from the suction
tube or the attached nozzles (Fig. 3 ). ᆻHold the
appliance with the dust bin over a waste bin. ᆼPress
the locking mechanism on the dust bin cover
(Fig. 13 ). ᇄThe dust bin cover opens downwards
and the dust falls out.
Cleaning the lter
NOTE:
The appliance and the lter should be cleaned
regularly in order to maintain the suction power.
ᆺPress the lter release button at the rear of the
appliance.ᆻPull the lter holder out of the appli-
ance (Fig. 14 ). ᆼRemove the lter from the mount
(Fig. 15 ). ᆽTap out the lter and the mount over a
waste bin. ᆾRinse out the lter under running water
(max. 40°C). ᆿLeave the lter to dry for at least 24
hours before you insert the lter and mount into the
appliance again.
Cleaning the cyclone unit
ᆺEmpty the dust bin, > „Emptying the dust bin“ on
page 18. ᆻPress and hold the dust bin release catch
on the underside of the appliance
(Fig. 16 /1). ᆼTip the dust bin towards the connec-
tion port for the suction tube and pull it downwards
(Fig. 16 ). ᆽTurn the lter eece anti-clockwise and
pull it downwards from the cyclone unit (Fig. 17 ).
ᆾTurn the cyclone unit anti-clockwise and pull it
downwards from the appliance (Fig. 18 ). ᆿTap out
the lter eece and the cyclone unit over a waste
bin. ᇀUse a dry cloth to remove any remaining dust
and dirt.
Inserting the cyclone unit
ᆺConnect the cyclone unit to the appliance so that
the two arrows on both components line up. ᆻTurn
the cyclone unit clockwise so that it clicks into place.
ᆼAttach the lter eece to the cyclone unit with the
seal facing away from the appliance. ᆽTurn the lter
eece clockwise to lock it in place. ᆾPlace the dust
bin on the appliance in a slightly inclined position.
ᆿPush the dust bin towards the handle to lock it in
place.
Removing and cleaning the brush roller
ᆺRelease oor nozzle as necessary and remove it
from the suction tube (Fig. 4 ). ᆻPush the brush
locking mechanism on the underside of the oor
nozzle to the side (Fig. 20 ). ᆼLift the brush roller
from the oor nozzle (Fig. 21 ). ᆽRemove any dirt
and hairs from the oor nozzle and from the brush
roller. If necessary, you can carefully use a pair of
scissors as an aid.
Accessories
• Hygienic exhaust lter - 0698002 (Fig. 22 /A )
• Brush roller- 0698413 (Fig. 22 /B )
• Separator with lter - 0698401 (Fig. 22 /C )
• Dust bin assembly - 0698405 (Fig. 22 /D )
• Wall mount - 0698011 (Fig. 22 /E )
• Mains adapter - 0698003 (Fig. 22 /F )
• Rechargeable battery - 0698004 (Fig. 22 /G )
Troubleshooting
Before you contact our customer service department
or send the appliance to the Dirt Devil customer
service department, you will nd a lot of additional
information in the service area of our website which
will help you solve problems:
www.dirtdevil.de/service
WARNING!
Switch o the appliance before you start trou-
bleshooting. Never use a faulty appliance, mains
adapter or rechargeable battery.
!
EN
18