Specifications

23
http://192.168.0.1/fs/registration/setup.html
This screen is the installers dialog screen. The Registration-Installer section will take an
installer through peaking the dish, manual and automatic cross pol tests (ACP), and
registration.
Registration-User will allow a user to manually register a system that has already been
installed by a certified technician. This dialog is used by a user to upgrade their system
from a DW4000 to a DW6000. They will be supplied with a rather long registration key
to enter during the upgrade process.
Antenna Pointing is normally used by a licensed technician to re-point and test a dish that
has been disturbed and is no longer pointing to its commissioned satellite.
The installer can point the Direcway satellite dish to a transponder on one of many
satellites. A chart is provided that shows the satellite pointing data used by the installers.
Satellite based commissioning can be done with the dish pointed to any valid Direcway
satellite and transponder. Once the IDU (DWx000) is commissioned it will only work on
the satellite and transponder pair it was commissioned to.
Steps taken during satellite based commissioning:
1) Power on Self test of DWx000 and boot FALLBACK.BIN. Power Light will flash
upon successful start up.
2) Installer will tune and perform Automatic Cross Pol (ACP).
3) Establish connection with NOC Registration Server.
4) Force ranging to adjust transmitter power.
5) Download encryption keys for secure registration processing.
6) Upload unit serial number.
7) Display User Agreement
8) Retrieve SAN/PIN numbers for registration and commissioning servers.
9) Download SiteID from Commissioning Server.
10) Download satellite and transponder information in MAIN.BIN.
11) Power restart IDU. If MAIN.BIN fails then will try FALLBACK.BIN. If
MAIN.BIN works then all lights will display steady state.
12) Remaining configuration files downloaded from NOC.