Manual
Table Of Contents
- About This Manual
- CHAPTER 1: Overview
- CHAPTER 2: Legal issues & facts
- CHAPTER 3: Installation
- CHAPTER 4: Operation
- CHAPTER 5: Front Panel Control
- CHAPTER 6: Remote Operation
- Introduction
- Status - Overview
- Status - Sync
- Status - Network
- Status - Device
- Status - Input Streams
- Status - Output Streams
- Matrix
- Advanced - Overview
- Advanced - PTP Settings
- Advanced - PTP Unicast
- Advanced - PTP Profile Customized Settings
- Advanced - Current PTP Master
- Advanced - PTP Statistic
- Advanced - PTP Clock Setting
- Advanced - Network Advanced Settings
- Advanced - PTP Jitter
- Logging
- Statistic
- CHAPTER 7: Troubleshooting and Maintenance
- CHAPTER 8: Technical Data
- Index
- Glossary
- Appendix A - Stream State Messages
- Appendix B - Firmware Update
- Appendix C - AES3 Transparency
page 86 of 88 Montone.42 Manual - Version 2.0
Appendix C - AES3 Transparency
Appendix C - AES3 Transparency
Firmware 4.5 / 4.16 introduces support according to SMPTE ST 2110-31 (AES3
Transparent Support).
For transparent AES3 transmission:
• set Audio Format to ‘AM824’ (see Output Stream Settings on page 57)
• set Subcode Transparency to ‘on’ and define the Transparency mode
(see MADI 1 to 4 on page 38)
NOTE
To accomodate the most applications (e.g. Dolby E transmission) transparency
mode VUCP is sufficient.
Full transparency pass-through of the incoming subcode data may lead to a corrupt
output signal when no signal is available from the assigned input source.